12V Wind Turbine Generator Kit, 5 Blade Gourd Shaped Wind Generator with Nylon Fiber Blades and IP67 Controller

Key features

• 360 Degree Wind CaptureVertical wind turbine generator uses a no yaw vertical shaft design to catch wind from any direction. Works well in shifting breezes near buildings rooftops docks and boats.
• 5 Blade Flange StructureWind generator kit features 5 flanged blades fixed inside the frame to reduce blade detachment wind speeds up to 45 m s for home yard cabin and pathway areas.
• Quiet Double Bearing RotationBuilt with a double bearing structure for quieter running than horizontal . Fits suburban backyards rooftop setups and locations near bedroom windows with noise concerns.
• Nylon Fiber Blade BuildGourd shaped turbine includes 60 x 37 cm reinforced nylon fiber blades with aluminum alloy and stainless steel parts. Rated for 11 m s operation in coastal and conditions.
• 12V 24V Auto Sensing ControlIncludes an IP67 controller that automatically identifies 12V or 24V systems. Suitable for off grid cabin battery charging solar hybrid installations and fishing boat power setups.

Spec: Item Type: Wind Generator Material: Nylon fiber, aluminum alloy, stainless steel Weight: Approx. 10250g/361.56oz Single Blade Size: 60x37cm/23.62x14.57in Controller Voltage: 12V 24V (automatic identification) Controller Protection Level: IP67 Installation Method: Flange installation Blade Number: 5 pieces Rated Wind Speed: 11m/s Safety Wind Speed: 45m/s Generator: Three phase AC permanent magnet synchronous generator Adjustment Mode: Wind angle automatic adjustment Scope of application: Suitable for home, ship, marine, monitoring use, solar and wind energy hybrid system. How to Use: 1. Align the 5 pairs of impeller holes on the blade with the holes on the hub, place the pressure plate to screw in the hex screw (no need to tighten). 2. Screw all put after tightening with hexagonal wrench (5 blades installation method is the same) . 3. Connect the two wires of the wind turbines to the transmission cable, the red wire to the positive pole, the blue wire to the negative pole, and tie the connection end 100 mm with tape. 4. Put the wind turbines on the tower pole, and tighten the screws. 5. Connect the cable from the wind turbines to the battery, with the red wire connected to th

Free shipping included. 30-day hassle-free returns.