ACEIRMC DC 6-30V Timer Relay Programmable Delay Relay Module Cycle Timer with LCD Display / 5V Micro USB, Smart Home Controller (10pcs)
Key features
- Programmable delay modes to control the relay timings, widely used at smart home, industrial control, automatic irrigation, indoor ventilation, protection equipment etc.
- Operating voltage: DC 6V - 30V, support micro USB 5V power supply. High level trigger: 3V - 24V. NO(Normally open) maximum load < AC 250V/10A, < DC 30V/10A. Timing range: 0.1s ~ 999mins (continuously adjustable).
- Built-in a diode to provide protection against accidental reverse polarity for the circuits.
- If no operation within 5 minutes, the digital tube of the relay board will turn off automatically. Pressing any button can wake it up.
- OP(conduction time) / CL(off time) / LOP(circuit times) can be set individually, and the parameters are mutually independent. All parameters are permanently saved once set. The functions and parameters can be reviewed or changed at a later time.
Product parameters:Voltage: 6V~30V(support micro USB 5.0V)Output Capacity: can control no more than DC 30V 5A AC or 220V 5AQuiescent Current: 20mAOperating Current: 50mAOperating Temperature: -40℃~85℃Timing Range: 0.1seconds to 999 minutes(continuously adjustable)Trigger Signal Source: High voltage level trigger(3.0V~24V), signal ground and system ground are not connected to improve system anti-interference ability(or you can connect them).Optocoupler Isolation: improve the anti-interference ability, after the parameter setting, it will memory forever . Warning: Relay contact is passive and electricity production; 1 channel has the control function on / off.Operation Mode:P1: After triggering signal, switch is connected for "OP" time, then disconnected; within the "OP" time:P1.1: if trigger signal again, it is invalid.P1.2: if trigger signal again, restart timing.P1.3: if trigger signal again, switch is disconnected, stop timing.P-2: After triggering signal, switch is disconnected for "CL" time, then switch is connected for "OP" time, and disconnect after timing.P3.1: After triggering signal, switch is connected for "OP" time, then switch is disconnected for "CL" time, and enter lo
Free shipping on orders $50+. 30-day hassle-free returns.







