5x10mm Thin Shim Washers Stainless Steel 40pc 0.1-0.5mm 5mm ID

Key features

• 40 PIECES, 4 THICKNESSES: 10 each of 0.1mm, 0.2mm, 0.3mm and 0.5mm. Stack them to reach any gap from 0.1mm up to 1.1mm in 0.1mm steps, so one kit covers the full adjustment range instead of ordering a single size and hoping it fits.
• EXACT 5 x 10 mm SIZE: 5mm inner diameter, 10mm outer diameter, DIN 988 precision shim washers. Measure your shaft before ordering, this listing is the 5x10mm size only. Other inner and outer diameters are available in the same range.
• STAINLESS STEEL THROUGHOUT: corrosion resistant material, not plated mild steel. Holds up in gearboxes, engine bays and humid workshops without rusting or staining the parts it sits against.
• DEBURRED AND FLAT: tight tolerance shim washers with clean, deburred faces that sit flush instead of cocking the part. For bearing preload, end float, pulley alignment and squaring up assemblies where a flat washer is too thick.
• RC, MOTORCYCLE AND WORKSHOP USE: shims for RC car and truck builds, motorcycle and starter motor spacing, small bearing preload on 5mm shafts, plus general machine and linkage packing.

A complete 5 x 10 mm shim washer set for anyone who needs to adjust a clearance precisely instead of approximately.You get 40 stainless steel shim washers: 10 pieces each in 0.1mm, 0.2mm, 0.3mm and 0.5mm. Because they stack, the four thicknesses cover every gap from 0.1mm to 1.1mm in 0.1mm increments. One kit does the job of ordering four separate sizes, and you keep the leftovers for the next job.All washers share the same 5mm inner diameter and 10mm outer diameter, made to the DIN 988 precision shim standard.Common uses:RC car and truck buildsRC car and truck buildsMotorcycle and starter motor spacingMotorcycle and starter motor spacingSmall bearing preload and end float on 5mm shaftsSmall bearing preload and end float on 5mm shaftsMachine, bracket and linkage packingMachine, bracket and linkage packingModel engineering and fine mechanical assembliesModel engineering and fine mechanical assembliesDeburred flat faces mean they sit flush against the part instead of cocking it, and stainless steel means they will not rust in a gearbox, an engine bay or a damp workshop drawer.Please measure before ordering. This listing covers the 5 x 10 mm size only. If you need a different inner or

Free shipping included. 30-day hassle-free returns.